Clearance lights (red on rear, amber elsewhere).Check that the safety belt is securely mounted, adjusts, and latches properly.Ĭheck that all external lights and reflective equipment are clean and functional, including:.Test that the heater and defroster works.Check that air horn and/or electric horn are operational.Test that dash indicators work when the corresponding lights are turned on: Windshield washers must operate correctly if the vehicle is equipped.Check that the wiper arms and blades are not damaged and operate smoothly.Non-power steering vehicles: Play should not exceed 10 degrees (or about two inches on a 20-inch wheel) when you turn the steering wheel back and forth.Power steering equipped vehicles: With the engine running, play should not exceed 10 degrees (or about two inches on a 20-inch wheel) before the front left wheel barely moves when you turn the steering wheel back and forth.One properly charged and rated fire extinguisher.Windshield should be clean with no illegal stickers, obstructions, or damage to the glass.Mirrors should be clean and adjusted properly from the inside.The speedometer should not be obscured or obviously broken.Check for proper operation and acceptable readings on the air and vacuum gauges.The gauges should show the alternator and/or generator charging otherwise the warning light should be set off.The temperature gauge should begin to climb to the normal operating range.Confirm that the temperature gauge is working.If equipped with an oil temperature gauge, it should begin to gradually rise to a normal operating range.Make sure that the pressure gauge shows increasing or normal oil pressure, otherwise that the warning light goes off.Confirm that the oil pressure gauge is functioning.Confirm the vehicle is in �park� and start the engine.Start the engine and then slowly release the clutch.If any of the components mentioned above are not belt driven, you must make sure that the component(s) are operating properly, are not damaged or leaking and are mounted securely. Confirm that there is an adequate power steering fluid level that is above the refill mark.Ĭheck these belts for cracks, frays and snugness (at most 3/4 inch play at center of belt):.Indicate the location of the power steering fluid dipstick.b) Removing the radiator cap if the engine is not hot and visually checking the coolant level.a) Checking the reservoir sight glass, or.Make sure the oil level is within safe operating range and above the refill mark.Inspect hoses for "good" condition and leaks.Look for dripping fluids on the underside of the engine and transmission.Look for puddles on the ground that would indicate a leak.This varies from state to state.Ĭheck your specific Maryland CDL Information for details. Depending on where you live, you will either have to provide a proper They are given either by a state tester or by a state approved third party The three-part skills tests must be scheduled (often more than a week ahead). Memory aid allowed and it cannot be altered or include notes or additions. License Manual during the Vehicle Inspection test segment. In many states, a driver may use the Memory Aid found in the Commercial Driver's Maryland CDL Handbook (Commercial Driver's License Manual). The Maryland Vehicle Checklist Inspection (walk-around) test is explained A driver is not required toĬrawl under the vehicle during the test. Under the hood engine compartment inspection. The Maryland vehicle inspection test (walk-around) requires the driver to point out vehicle componentsĪnd explain what you are checking and why to the examiner. Vehicle Pre-Trip Checklist Inspection - Maryland CDL Skills Tests:
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |